Fluent Help Center

    Canada
    (587) 844-5377

    Our phone number has changed!

    US
    (385) 832-9055

    ADC-VDB770 - Reconnect if the wireless network or router changes

    If the ADC-VDB770 disconnects from the user's network due to networking hardware replacement (e.g., a new router or access point) or Wi-Fi settings change, reconnect the device using AP mode or WPS.

    Reconnect the VDB770 using AP mode:

    1. The camera is in Access Point (AP) mode when the button LED is blinking white. If necessary, access AP mode by holding down the doorbell button for 35-40s and release when the LED turns to blinking white.
    2. Using a Wi-Fi-capable device (e.g., smartphone or computer), find and connect to the camera’s network; the SSID should have the format ADC-VDB770 (XX:YY:ZZ) where XX:YY:ZZ is the last 6 characters of the MAC address, which is printed on the included reference card.
    3. On the same device, open a web browser and enter http://vdb770install or 192.168.1.1 in the web address field. Follow the on-screen instructions to add the ADC-VDB770 to the Wi-Fi network. Verify the LED turns solid green, indicating the connection is complete.


    Reconnect the VDB770 using WPS:

    Note: Not all routers have the WPS feature. If WPS is unavailable, use AP mode to reconnect the VDB770.

    1. Press and hold the doorbell button on the VDB770 for 30-40 seconds until the button LED starts blinking blue.
    2. Put the router, access point, or Wi-Fi extender into WPS mode. This typically involves pressing the WPS button on the networking device. Refer to the manufacturer's manual for more information.
    3. Wait approximately 2 minutes for the VDB770 to connect. Verify that the button LED turns solid green.


    Troubleshooting

    1. If there are issues connecting the Alarm.com Video Doorbell to the account, power cycle the camera by pressing and holding the main button for 40-45 seconds until the LED starts blinking yellow. After the camera reboots, try connecting again.
    2. If possible, power cycle the networking device that the camera is connected to, or move the camera closer to the networking device.
    3. If issues persist, factory reset the Alarm.com Video Doorbell by pressing and holding the main button for at least 45-50 seconds until the LED starts blinking red and green. The camera will reboot with factory defaults.

    Important: If the camera was previously installed to an Alarm.com account, it will need to be deleted before it can be installed again.

    Fluent | We Speak Home

    Did this help resolve your question?

    Can’t find what you’re looking for?

    Our award-winning customer care team is here for you.

    Contact Support
    Fluent's Blog Fluent on Facebook Fluent on Twitter