What is Needed
2 – AA batteries
1 – Small Flat-head Screw driver
- Remove the sensor from the mounting bracket by pressing down on the button on the top and swinging the sensor toward you.
- Press the 2 tabs on top of the sensor and the 1 button on the bottom, then pull the sensor straight out.
- Remove the old batteries.
- Wait 15–20 seconds.
- Install 2 replacement AA batteries.
- Slide the sensor back into its housing and place it back on the mounting bracket by putting in the bottom first and swinging the sensor up until it clicks into place.
If the error persists, please call our Account Specialists for further assistance.
CA (587) 844-5377 US (385) 832-9055.png)
